Dixon-valve 100 TON RAM SEC02 External Swaged Holedall User Manual download pdf (Page 5)

100 Ton Ram Instruction Manual

1-1/4" through 4" Standard & Long Holedall Swaged Couplings

customer service 800•355•1991

3Section 2

Lubricate the I.D. of both die halves with Crisco®

(recommended) or high viscosity oil or heavy duty

grease.

Lifting up the hose, insert one die half under the

hose. Lower the hose so that it rests on the die.

Insert the other die half. Make sure that the seams

of the die do not line up with the seams on the die

holders.

Continue to jog the cylinder until pressure begins to

lever in the “FORWARD” position. Loosen the bolt

on the tie down bar that is holding the die in place.

Move the tie down bar so that the entire flange on

the pusher will clear. Move any other tie down bars

that may interfere with the pusher. When the pusher

contacts the die release the pressure.

Important!

Inspect the position of the stem and

ferrule with the pusher. Make sure the collar (ring)

on the stem is in contact with the ferrule before

proceeding.

Bring the hose with the stem and ferrule through the

die bed. Insert the stem into the pusher so that the

ferrule contacts the pusher. Make sure that there is

sufficient room between the die holders and the end

of the ferrule to comfortably insert the die halves into

the die holders.

1 2 3 4 5 6

No comments

Dixon-valve 100 TON RAM SEC02 External Swaged Holedall User Manual Page 5